英语
西班牙语
俄语
阿拉伯语
1
.jpg?imageView2/2/format/jp2)
How to install the hot and cold two-control pull-out faucet?
1. Check the accessories first, then take out the switch body of the faucet, unscrew the nut and the gasket, and then insert it through the right installation hole, repeat the process of the main body just now, and then insert the main body of the faucet from the installation hole on the left thrust into;
2: Put the main body of the faucet and the separate non-slip ring and gasket back through the bottom, and then screw on the nuts. Remember not to misplace these small parts, otherwise it will be troublesome!
3: Take out the sealing rubber gasket and tighten it together with the small nut at the end of the short shower hose into the device hole; don't forget the sealing gasket;
4: The last step is to connect the two hot and cold water inlet pipes, and then connect the water inlet pipes to the angle valve.
zinc faucet single lever hot/cold water wall-mounted kitchen mixer, sink mixer UN 20515B
zinc faucet single lever hot/cold water wall-mounted kitchen mixer, sink mixer UN 20515B
Aerator With Air-In Technology Mixes Water With Air To Make Lighter And Softer Water Droplets That Mimic The Feel Of Natural Rain;
Single Hole Installation;
Zinc Body Construction;
One-Handle Lever Handle Makes It Easy To Adjust The Water;
